|
|
Anoplate Processes:_AnoLube
9627A
|
|
Prevents
corrosion, galling, seizing, and
fretting
AnoLube 9627A Dry Film Lubricant is a lacquer-like coating containing molybdenum disulfide and corrosion inhibiting pigments. This
air drying material prevents corrosion, galling, seizing, and fretting. It is a low friction coating which exhibits long wear life when operated at – 320 F to +
300 F under loads exceeding 100,000 psi.
AnoLube 9627A should be applied where
baking with the longer wearing,
heat cured AnoLube 9620A is not
desireable (e.g. completed
assemblies, plastics, etc.).
Once AnoLube 9627A has been
allowed to cure, it is virtually unaffected by atmospheric and fretting corrosion, solvents, acids, oils,
degreasers. The material can
be purchased in easy to apply
aerosol cans for field touch up.
AnoLube 9627A may be applied to
all properly prepared metallic and
nonmetallic surfaces by spraying or dipping.
Excellent Corrosion Protection, Chemical Resistance, and Long Wear Life are AnoLube
9627A's outstanding properties.
Recommended Usage
- Where
application of heat-cured
lubricant is not possible
- Where
conventional fluid
lubricants are difficult
to apply or retain where
mechanisms require
life-long lubrication
- Where
operating pressures exceed
the load-bearing capacity
of ordinary oils and
greases
- For
parts which are seldom
lubricated once they leave
the factory and where
permanent, life-long
lubrication is desired
- For
sliding motion
applications such as plain
and spherical bearings,
flap tracks, hinges,
threads, and cam surfaces
- Where
clean operation is desired
(AnoLube 9627A won't
collect dirt and dust as
grease and oil do)
- Where
parts are subject to
frequent disassembly
- Parts
which operate with
reciprocating motion,
loaded to 15 psi or less,
when contamination with
fluid lubrication is
likely
- Where
protective coating and
sacrificial break-in
lubricant is needed
- Where
easy release is desired
(such as acme nuts and
screws and PVC molds)
Physical Properties
- NET WEIGHT PER GALLON: 9#
- SOLIDS CONTENT: 35-40% (BY WT.)
- VISCOSITY:
30-40 SEC. (#3 ZAHN CUP @ 77F)
- FLASH POINT: 45F (T.O.C.)
- OPERATING TEMP. RANGE: -360F TO + 500F
- VEHICLE TYPE: EPOXY-PHENOLIC
- LUBRICATIVE PIGMENT: MOLYBDENUM DISULFIDE
- COLOR: FLAT DARK GRAY
- SHELF LIFE: 2 YEARS
- VACUUM OUTGASING: NONE @ -6 TORR
- VEHICLE
TYPE: 100% EPOXY
- SPECIFICATIONS: EXCEEDS REQUIREMENTS OF
MIL-L-46147A (LUBRICANT,
SOLID FILM; AIR CURED)
- WEAR LIFE:
120-220 MINUTES DEPENDING ON SURFACE
PREPARATION (FALEX @ 1000 LBS GAUGE LOAD)
- LOAD CARRYING CAPACITY:
2500 LBS. (FALEX E.P.)
- CORROSION RESISTANCE:
600 HOURS IN 5% SALT SPRAY PER ASTM B117 (1/2 MIL COATING) OVER PHOSPHATE)
|
|
|
